The display cabinet decoration is not the same, what style display cabinet is based on the decoration and installation.So how do we do that?This convenient knowledge is popularized by shenzhen fan road display factory.
One, rely on wall display ark.
1. The height of the wall container is 2400mm(back plate 2400mm), and the width is 300~500mm;Shelves inside the plane layout design should consider does not affect the fire control facilities, air conditioning, all kinds of access port, door and public channel use requirements, such as tall ark, back under air outlet, warm wind mouth not less than 500 mm.
2. Height dimension of the partition board of the display cabinet: it is 1350mm high to be separated from the edge of the channel along the edge of the counter, and then to the wall with a height of 2400mm.If the partition between the two cabinets is a column and the cylinder is located at the edge of the channel, the partition height of the cylinder to the wall is 2400mm;If the partition between the two cabinets is a column and the cylinder is not located on the edge of the channel, the partition height of the cylinder to the wall is 2400mm, and the partition height of the cylinder to the channel is 1350mm.
3. If the jewelry display case requires the lintel, the bottom of the hanging lintel is 2400mm from the ground, and the height of the hanging lintel is 300mm. It is necessary to make the technique of using acrylic plate hollow word, and pay attention to the connection between the display and the lintel.Therefore, it is necessary to start the production of Shanghai exhibition cabinet and the situation of the site according to the brand image.
Ii. Middle island display case.
1. The space height of the display cabinet is high, and the depth of the extension counter is half of the depth, which is 1350mm high partition.
2. The partition height between the main aisle and the reverse booth in the garment area is 2400mm;In addition, the display cabinets are separated by 600mm from the channel line to a height of 1350mm.
3. The shelf height is 1350mm (except special shelf).Back off
4. The height of the flat cabinet is 900mm and the width is 600mm.
5. If the display case requires lifting lintel, the bottom of the lifting lintel is 2400mm from the ground, and the height of the lintel is 300mm, and it must be made by using acrylic sheet with hollow words, and it should be noted for the connection between the booth and the lintel.
3. Special display case.
1. The cash register area display case is designed and produced in actual situation.
2. The upper part of the atrium is to be displayed on both sides of the escalator and the cabinet should be fully transparent. The height is 1350mm.
3. If the display cabinet posts are on the channel line, the front side of the pillar must be made of image and the height is 2400mm.
In fact, the above requirements are the experience of integrating the development of the display cabinet for many years, to a qualitative product standard.A good display cabinet can improve the popularity of the goods and brand, always to prove the merits of the display case.
This article is provided by shenzhen Funroad jewelry display cabinet direct selling manufacturer: 20 years of jewelry store display cabinet design experience, 2018 will help you to rapidly improve the brand value.